Before starting the full automatic EPS shape molding machine, the operator should understand the equipment manual, equipment structure and working principle; Before starting the power supply, check the equipment carefully to see if there is oil leakage and screw looseness. Turn on the power only when everything is normal; To avoid problems, it is recommended to disconnect the main power supply and hang warning signs when checking the automatic block machine. When all staff and other supporting equipment are ready, the operator can turn on the automatic block machine. Cyclic operation; Untrained personnel shall not touch or operate the full-automatic EPS molding machine at will or make abnormal noise or noise in the process of work, which needs to be stopped for maintenance, and can continue to work after the fault is solved; Of course, before the end of each shift, the mixture in the cloth box and the mold should be used up, so as not to affect the following work due to long-term placement; If the mixture in the mold is insufficient, do not press again to clean it manually; Otherwise, the automatic EPS shape molding machine will control the switch at the "power off" or "stop" position after each shift.
When the full automatic EPS molding machine is running, the mixture on the tray must also be cleaned and then piled into a piece; Other auxiliary equipment, such as batching machine and mixer, must be cleaned before turning off the power; Once the tools you use are in place, you can start the workflow. Of course, during the operation of the automatic EPS molding machine, attention should be paid to the unqualified operation without strict training, and it is not allowed to operate the equipment at will; In order to ensure the normal operation of the EPS automatic molding machine, it is necessary to ensure the stability of the voltage, and its fluctuation value shall not exceed or be lower than 5-10% of the voltage; The control cabinet shall be grounded during use to avoid safety accidents; The controller shall be covered or placed in a separate room to avoid dust damage to the equipment; Check whether the process switch of the automatic block forming machine is in place at any time. If it is loose, tighten it in time. The distance between the end of the travel switch and the sensing block is 5-8mm; Of course, when the cooler is abnormally hot, check whether the cooler of the automatic EPS molding machine is damaged, and replace it if it can be avoided; It must be replaced in time. Put a rubber scraper on the feed hopper of the equipment and adjust the clearance, otherwise the material will leak and the pressure head will stick to the material.
Post time: Mar-14-2023